[D94]

Hello all. I've been using the Terminator X Stealth EFI (550-1002) for a few years now. I decided to add the HyperSpark setup. Everything is installed, firmware updated to V3 (both 3.5" Handheld & ECU). New startup GCF Wizard config with proper settings for HyperSpark (with Stealth you have to change Reference Angle to 57.5° it defaults to 50.0°). My issue is when cranking, I'm not getting RPM signal and no start. 3.5" Handheld reads "Stall". Checked all connections, all new equipment right out of the box. Was getting late last night, plan on troubleshooting some more later when I get home from work. Was wondering if anyone experienced anything similar, maybe give me a clue on where to start looking? Thanks.
Pontiac 468, Comp Cams 256°/260° @ .050", Manual Transmission.