| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-16-2025, 01:37 PM
|
||||
|
||||
Vent Window "Cranks" and Seat Trim Retainers
One of our '64's has sloppy fit for the vent window "cranks." It appears that the problem is not with the male shaft from the vent window frame, but from the diecast "crank" that swivels to lock the window. The female bore in the "crank" is worn, allowing them to fall off even with the roll pin in place. Do the repro's fit decently?
Also, is there a trick to installing the "acorn" chrome trim on the outside of the seat "hockey puck" trim? Mine keep falling off. Thank you for any suggestions. '
__________________
BONESTOCK GOATS '64 GTO Tripower Hardtop (Wife's Car) '64 GTO Tripower Post Coupe (My Car) '99 Bonneville SE Sedan |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode