[performerrpm]

i dont think i really need the brace for this ud solid roller im putting in....its only a 271/[email protected] which i think plenty have ran a cam in this range with no problems...but since i bought the brace for this block and figure this cam and one other i have is the biggest im gonna put in a stock block, the 2nd cam is slightly smaller but ill use it with the mega brace. all the rest of my stock blocks will use tamer cams.

however i may have got ahead of myself...im putting in .045 restrictors,all the galley holes are just under 1/4" perfect for the 1/4x20 tap i used. ive only done one side but then i started thinking maybe i should not have tapped the whole depth of the galley so that i can tighten it up against the bottom thread?

i started looking and seen where steve 25 recommended just that. you guys think red loctite will keep them in place? i was going to use it any way just for safe measure but now it seems like im gonna be relying heavy on it holding.