| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
|
|
Thread Tools | Display Modes |
|
#1
10-13-2025, 05:02 PM
|
|||
|
|||
How to Solve Multiple Waves on '70 Rear Deck Filler Panel?
A fellow who used to do some welding for me has since retired. He put new rear quarters and filler panel on the car and I was about to epoxy prime and couldn't believe the waves on the filler panel.
There are 4-5 large low spots that cover all but the drivers side last 8 to 10 inches. I filled with filler and sanded down to the high spots but have no idea how to transition that far to the good section. I could float the entire panel but then how to transition to the ends. What to do on the sides is also doubtful. I ran a DA down the long edges - vertically - with no back glass in. I'm out of my area of knowledge by a long ways and haven't had luck searching as just get welding suggestions on it. Thanks! |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode