[MidnightAuto]

Been off the board a bit, car has been asleep. With that said I am tried of squirting gas in bowl after car sits a week. It’s also killing my starter. So I’m going to adds a pusher pump. Would love feedback on my plan.

So the current setup 1/2 inch fuel line into regulator. Robbmc mech pump, then standard tripower lines. Return vapor line from regulator back to tank.

One constraint- I’m not splicing my existing 1/2 inch steel braided line to insert a pump.

So my idea is to put a Y in the sending unit fuel out side, adding a new line, reduce to 5/16, then pusher pump, then checkvalve. 5/16 line continues up to engine and spliced in with a T on the short line (seen in pick) from fuel block to center carb.


Are there any issues with this approach? Pics attached. Lmk thoughts. Thanks guys