| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-25-2003, 07:11 PM
|
|||
|
|||
Anyone know where you can get the fittings that go into the manifold on a 66 Tri-power for the PCV? Thanks.
|
|
#2
01-25-2003, 07:11 PM
|
|||
|
|||
|
Anyone know where you can get the fittings that go into the manifold on a 66 Tri-power for the PCV? Thanks.
|
|
#3
01-25-2003, 08:29 PM
|
||||
|
||||
|
Try Paul Spotts, the 66 Tri-Power have these pressed into the manifold and the 65 had screw in fittings. I believe Paul had these pressed in ones on his site and was going to have them made up. Give him a call. http://www.spottsperformance.com
Robert Williams
__________________
"Three may keep a secret, if two are dead" ~ Benjamin Franklin ~ |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
