| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
12-23-2003, 08:15 PM
|
|||
|
|||
I ran into the same problem I bought the cam bearing tool (Lisle) and installed them myself, the front one being the hardest because of the stand in the way(putting it on a bench would be easier) but since your in that far why would you not change the rod and mains? you can cheat but I would make sure that your oil holes are lined up(you do that by looking down the main saddle)
good luck Brent |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
