08-08-2004, 01:23 PM

wlpsyp

Ultimate Warrior

Join Date: Mar 2003

Location: Alexandria, Louisiana

Posts: 1,135

I use .024 wire for all my welding, floor pans, 1/4 patchs, trunk pan etc. Get some old sheet metal and practice with it. Make sure the surface is to bare metal and the ground has good contact with bare metal, go slow and play with your settings.

I see no way to work on or replace the outer wheel house with out removing the 1/4 area unless you are just doing a small patch in the housing. If it is the entire housing you are replacing you are going to have to remove the area of the 1/4 around it at least.

Bill

__________________
_____________________________

It is not a problem.... It is just a blood pressure monitor.

Reply With Quote

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 10:42 AM.

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

Menu

About Us