[Droptop64]

I put seatbelts in my 64 GTO convertible. It had none in the back when I purchased it, and I decided to put belts in for three. I got mine from Julianos'. The lady on the phone knew the proper length, and almost walked me through everything I needed to tell her to make sure I had the right setups. I bought the reinforcing plates as well. They are threaded with a welded in nut, and i mamaged the install with only one person. I picked an area that would be a straight pull from the seat joint between the top and base, and put the holes there. If i remember, I put the outside holes about 4 inches inside the bottom of the side panel where the floorpan curves up, and spaced the other two holes accordingly. (CHECK FOR STUFF LIKE GAS AND BRAKE LINES) I used latemodel looking belts, but Juliano's has both. Hope this helped.