| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
08-11-2002, 12:53 AM
|
|||
|
|||
you'll need to change the ecm,the harness, intake, fuel pump[or regulate it]and maybe the dist[ i'm not sure if the module is the same or not].
if you're going to swap it out i'd go to a tbi setup instead of the tpi. you'll still need to change the above but the system is much simpler and less hassle in the long run. check the tpi harness at the rear of the intake plenum and look for "rub throughs" in the harness. trouble in this area was common after the intake had been off once. mike
__________________
so many pontiacs, so little time.................. moderator is a glorified word for an unappreciated prick.................. "Only two things are infinite, the universe and human stupidity, and I'm not sure about the former." --Albert Einstein "There is no such thing as a good tax." "We contend that for a nation to tax itself into prosperity is like a man standing in a bucket and trying to lift himself up by the handle." - Winston Churchill |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
