[mmm]

Thanks for the reply Scott. I just went out to the garage again to make sure I wasn't seeing things, and it sure looks like the tray has 4 mounting holes where the 2 & 4 caps are (its a 3/4 tray) and only the #3 cap has 2 mounting holes. Needless to say I see credit card usage in my future! This is going to be a relatively mild (as this board goes) street engine, so I may follow your advice and go with the baffled pan setup. My next question is... I have seen suggestions on this board that say a crank scraper & baffled pan is a good setup for the avg. street machine. Are crank scrapers a pain to install, and has anyone ever had a problem because they used one- i.e. it broke, fell off, etc...? Is the baffled pan sufficient on its own?
Thanks again,
Mike

I'm right at home in a filthy garage