| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
09-23-2005, 07:34 AM
|
||||
|
||||
Seemed to spin easy, major reason we tore it down was to 0 deck the block as the pistons were too far down the hole.
Mains are slightly out of round when checked with a bore gauge so we are now line honing the block, crank measures different any place you check it so it is now being .010/.010, and the big rods all measure different so we're redoing them. Every component has atleast 1 issue, even the block which was bored and honed has a .005 taper in most holes. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
