| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
09-25-2005, 05:30 PM
|
|||
|
|||
alrighty then, where do i begin for a bottom end build up?
is summitt or jegs the way to go or do i want to start with KRE and JBP? do i want forged or hypereutectic pistons (not planning on using nos)? do i have to get the block bored (this may be a slight problem b/c i'm not too confident in the local shops familiarity with Pontiac)? does a rotating assembly need to be "balanced and blue printed" for a 12 sec. street car? if so, can this be done without having the assembly in the destination block? can i use a stroker kit without needing any machine work? thanks in advance to any and all who take (and have taken) the time to help.
__________________
 "Second place is the first loser""That's no oil leak....that's just sweat from all that horsepower." |
|
#2
09-26-2005, 01:15 PM
|
||||
|
||||
|
__________________
1994 Formula 535ci NA CV-1 - single 1050 with c14 - 940hp@7000/825tq@5200 Pontiac Powered 4th Gen Project Progress 
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
