| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
01-21-2006, 01:38 AM
|
||||
|
||||
I've noticed this too while checking timing with the plates facing down. Curve will stop at my target 32 deg. than as revs increased timing would slowly increase untill I chickened out. Then I read an article by Rocky R. about this and flipped the center plate and timing curve stopped at desired rpm.
Glad to see some research to back this thou.
__________________
best 1/4-11.37 @ 118.03, 96 heads on motor. 11.05 @ 120 on 100shot. 
|
|
#2
01-21-2006, 02:43 AM
|
||||
|
||||
|
In what arrangement were the center plates of factory HEI units , numbers up or down ?. Also would the use of the light/weak aftermarket springs allow the weights to reach an over advanced position as the springs that these weights/cam were intended for were heavy rate. Great post
Last edited by P@blo; 01-21-2006 at 03:05 AM. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
