| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
02-09-2006, 06:09 PM
|
||||
|
||||
I really would like to fill the block, because it would make me fill more confident about the block strength. I guess it would not be a problem to run an oil cooler. What brand block fill do you guys recommend? Any certain materials?
Thanks
__________________
1976 trans am. 400 .040" over stock crank, CAT rods, speedpro flat tops, 72cc eheads, rpm intake, quick fuel 750, xe274, 1.5 HS. Built 700r4 (by me) w/3200 EDGE converter. 3.73's hustler headers. Flowmaster exhaust system. 17" torque thrust II's |
|
#2
02-10-2006, 12:25 AM
|
|||
|
|||
|
Quote:
Brock&White (701) 222-3010 |
|
#3
02-10-2006, 09:12 AM
|
||||
|
||||
|
I used the Dude's stuff. REAL easy to work with. Some were saying it wasn't required but since I never heard anything on the down side of filling I did it. AND since you should/must fill before boring and honing the block I felt this was not something I could have done after the motor was assembled or stepped up a peg or 2. And when I was inquiring some mentioned that their motors have been tanked after filling so I see no down side other than the extra weight.
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
