| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
11-14-2006, 11:25 PM
|
||||
|
||||
BRA-1649..still working after 1 week, no drips, no noises. Engine seems cooler in bumper-to-bumper traffic but that could be my swap to dual carbs and Idle ADJs.
|
|
#2
11-16-2006, 06:46 AM
|
||||
|
||||
|
I also assembled plate onto pump with no gasket, then got to whacking. I only whacked about a half inch around the center hole. I have no clearance problems due to heating or otherwise.
Besides, if there were any slow creeping clearance issues, the impeller would take care of that when contact was made.
__________________
"...ridge reamer and ring compressor? Do they have tools like that?" |
|
#3
12-24-2006, 03:26 AM
|
||||
|
||||
|
dumb question, but do they make a after-market highflow or revised pump that will work in a 67 8 bolt timing cover? I have seen in the catalogs that they make them for the 11 bolt but not the 8 ?
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
