["QUICK-SILVER"]

Originally Posted by Father&Son73T/A

Thanks guys,I will check it,I was having a problem with the bracket that holds the line that returns gases...I believe.. to the charcoal filter.It turns everytime I loosen the first(closest to person) nut and bolt,and I don't want to break it,it's aluminum with radiused eges and holding the line whic starts to bend....Well here's a pick...just to the left of the insulated fuel line and at about 7 oclock to the waterneck...are these repro'd if i break it?

That nut was bad about freezing up and the stud coming loose before you could get the line off. I have been able to get a thin wrench under the line bracket and hold the stud while breaking the nut loose.
A nut splitter might work if there is enough room to use one.
I think, I would cut the bracket before I would tear the line up, if I couldn't get the nut loose.
It would take some time but you might grind a side off the nut with a Dremel tool and get it loose.

Just caught this thread, hope it's not too late.

[Father&Son73T/A]

Originally Posted by "QUICK-SILVER"

That nut was bad about freezing up and the stud coming loose before you could get the line off. I have been able to get a thin wrench under the line bracket and hold the stud while breaking the nut loose.
A nut splitter might work if there is enough room to use one.
I think, I would cut the bracket before I would tear the line up, if I couldn't get the nut loose.
It would take some time but you might grind a side off the nut with a Dremel tool and get it loose.

Just caught this thread, hope it's not too late.

Not too late yet,I stopped before i did anything I would regret,does anyone repro this part?