| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
06-18-2009, 01:55 AM
|
||||
|
||||
Incorrect rocker geometry/pushrod length that has the stud biased too far to in the rocker slot,thus as the rocker approaches full lift it runs out of slot in the rocker arm and consequently binds the rocker arm on the stud.
That or as mentioned valve spring coil bind,or some other mechanical interference (guide to retainer) issue. A pic would help us understand the failure better.  Did it break on the underside of the rocker,or elsewhere? Did it also bend the pushrods on those locations??? What springs are being used here? What sorta seat/open pressures?? Fill us in and you'll get better feedback. 
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
