| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
07-08-2010, 09:58 AM
|
||||
|
||||
Put some hi-temp sealer on the plate. Lay it on top of the cylinder head, covering the heat riser hole on each head. Put some more hi-temp sealer on the top side of the plate. Install the manifold as you normally would. The plate is sandwiched between the intake gasket and the cylinder head. The thin (16 gage) will not interfere with fit.
__________________
BONESTOCK GOATS '64 GTO Tripower Hardtop (Wife's Car) '64 GTO Tripower Post Coupe (My Car) '99 Bonneville SE Sedan |
|
#2
07-08-2010, 10:22 AM
|
|||
|
|||
|
crossover block
I get it now. Thanks for that info amigo. And to all the other hombres that helped me out of another jam.
__________________
1965 Pontiac Lemans Convertible, 1957 Chevy 3600 dump bed, 1968 Ford backhoe.  http://picasaweb.google.com/orchidsk...vyiKGThcblmQE# |
|
#3
07-08-2010, 11:22 AM
|
|||
|
|||
|
Thats a Mr. Gasket gasket with the pates already in the gasket. If you need a new manifold gasket the gaskets are side by side in the parts book if your ordering from a parts store
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
