| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
10-08-2010, 08:14 AM
|
|||
|
|||
depending on the type of 455 engine you're building, you'll need a 30cc dish piston to keep the compression down.
|
|
#2
10-08-2010, 08:47 AM
|
||||
|
||||
|
Check in the Performance Parts For Sale. Firebird Crazy 1959 is offering two sets of bare 7K3 heads for $100.0 a set. If he wasn't so far away I would get a set for my 455. These are the last of the big valve heads with screw in rocker studs. Listed at 96 cc combustion chamber, on a 30 over 455 this will have a 9.14 cr. Perfect for a pump gas street motor. I know they don't have the end exhaust bolts holes. If you don't run headers they will be ok, with stock log manifolds or Ram Air Manifolds
Your location is listed a Maine, Firebird Crazy lists his location a White Lake N.Y. I think if I was in your position, it would be road trip time.
__________________
Its ok to giggle and snicker, Dont laugh and point Last edited by Ollie; 10-08-2010 at 08:56 AM. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
