[mtnbktrek]

Need pics of fan shroud or specs I just waited months for PY to get me a shroud I pull off fan rad support and drained rad I'm pi$$3d that it's not even close ... No holes drilled I have a 68 lemans conv there. Is a 400 in it and came stock w a 350 I want to make sure im right before I call PY in the morning my rad tank to tank measures 25.5" top to bottom is ~17" the shroud side to side is 27" it covers my rad openings

Thanks

[Greg Reid]

I replaced my '68 shroud with a repop...I remember it not being up to snuff...didn't look like the same finish as the original, but not that big of a deal. I thiink I did have to drill the holes. It does fit OK though.

[Andre]

I had a repo '68 shroud in fiberglass, and also have an orignal '68 shroud in plastic. The shape and size seemed generally the same. I will sell the '68 shroud if you need it. email me at [email protected]

[Greg Reid]

Yeah, I still have my original too...just had a cut in it. Looks like a previous owner wanted to be able to remove it without removing the fan. Very repairable but I still used the repop because it's not too bad and looks fine installed..Just a slightly different finish and I do recall drilling the holes now.

[68gtoMN]

FYI - all 68 shrouds, big car or small, were the same

[mtnbktrek]

They are def not the same I finally got mine corrected and huge difference