[grandville455]

Bret I noticed that too On the Bfcs Numbers, Definately was happier now, but i believe he added that 850 baseplate after the 274 dyno run? I could be wrong tho. Also It is obvious that the cam now is wanting more Fuel as shown with his A/F. I bet there is close to 10-20 hp out there yet just in A/F. Where was the timing? I say jet it up some more on the secondaries and run her for a baseline at the track.
Ryan
Where did u end up with jetting on this build? Is this a fresh engine Or just a cam swap?

Either Way I think its going to be faster than the 274 when all said and done, which it should if its close in comparison to the RAIV grinds. JMO

[mudbird]

IMHO I think it is all good Ryan. I would like to know your launch rpm and shift points too. R&R is right by my house!
( if I am not there) When are you going?


I do not have my old cam out yet. (got the acc. and rad. and stuff off)


I found the spacer stuff interesting... been thinking of a Jim Hand type spacer as I have run a 4 hole on mine before....