| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
01-21-2012, 04:47 PM
|
||||
|
||||
Temperature sensor on the front of the intake manifold?
|
|
#2
01-21-2012, 05:37 PM
|
||||
|
||||
|
A couple more photos are attached.
There is no a/c on the car. The temp sensor is a hard square plastic connector. The one in question is a round rubber connector. I could be way off base, but I seem to remember this wire being attached to the cowl. With that being stated, you would think I could find the male blade for this wire, but I can't. This wire is totally separate. The other wires going to the gen and the temp sensor were tape wrapped. There is a metal bendable wire holder on the cowl. I wonder if this wire is held in place by the holder. The only other wire going that direction is the blue one for the oil sending unit. |
|
#3
01-21-2012, 05:44 PM
|
|||
|
|||
|
Suppressor by the fan motor?
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
