[jims68ragtop]

Blower Motor Wire: The blower moter has a wire attached. The wire in question has the exact same connector as the one on the blower motor. The blower motor wire comes through the cowl on the passenger side and runs over to the blower motor in the engine compartment. The wire in question can't reach as far as the blower motor wire.

Idle Stop: I don't think I have an Idle Stop Soleniod. Where would it be located? I kind of assume it would be on or near the carb.

Fan Suppressor: The wire in question is a foot or more too short to reach the fan motor. The heater core/fan plastic box does encompass enough area to meet this wire; however, there is not a male blade anywhere in site.

On my wiring diagram, it shows a blk. dbl. wht. wire coming out of the fuse block in the engine compartment on the Tempest diagram. The diagram shows this wire running to the edge of the page and stopping. It also shows a Blk. Sgl. Lt Blue wire runnng off the page in the same loction along with a Blk. Dbl Yel. All three of these wires do not show where they go. How weird is that? Any more suggestions? I think the wiring on my Lemans is original, so I am hoping that somebody with original wiring can look where that bunch of wires comes out of the fuse block (shown in one of the first photos), and can find that separate black wire. It is very easy to isolate because all others in that bunch are pretty easy to identify, or they are taped together. Thanks.

[sluggo]

sliniod stop is on carb. though you dont need to take of the wire that goes down to the brake line maybe you did take that off. that wire comes directly from fuse panel.

[jmt455]

The idle stop solenoid is shown in this photo; it's at the top of the image, the plunger acts on the small tab on the throttle arm.


There should be one on your 68.

[wytnyt]

you can hook this to a test light and turn on accessorys to see if it comes on to isolate it

[azkeebler]

Hood light or tach?