| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
01-26-2013, 06:53 PM
|
||||
|
||||
"Casting Porosity" on a Forged Piston? I do not think that should be the case with any quality Forged Piston. I guarantee that you would not see that deal on a CP Forged Piston.
Tom Vaught
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
|
#2
01-26-2013, 07:18 PM
|
|||
|
|||
|
It looks like a piston stop mark but why would you use a set screw that is pointy to dig a hole in the piston two holes instead of one? You figure one is a Goof but two!To all the money you spent on that engine build, everything should be spotless. It looks like you are finding stuff that is usually fine turns out bad. I hope this is the last bad thing you will find on it. I would remove the rods, crank and inspect the bearings if I were you. I would strip that block and inspect everything before putting it in your car. Goodluck on your build, looking forward of a happy ending.
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
