[LiL Jack]

Originally Posted by RAIV-Z

Just curious to see if anyone else has had this done to their block and what the results were or if there are any other mods which should be considered while the engine is apart.

Mine are this way. Just not as deep as yours I would say.

[RAIV-Z]

Originally Posted by LiL Jack

Mine are this way. Just not as deep as yours I would say.

Did you modify the main bearings in any other way besides adding another oil hole?

[LiL Jack]

Originally Posted by RAIV-Z

Did you modify the main bearings in any other way besides adding another oil hole?

just made the hole bigger, there was no groove on the bearing.

[RAIV-Z]

Originally Posted by LiL Jack

Mine are this way. Just not as deep as yours I would say.

Who performed the machine work on your block and did your main bearing look anything like this?
This engine has only had a few NA dyno pulls.

[67'7F6'Bird]

Originally Posted by RAIV-Z

Who performed the machine work on your block and did your main bearing look anything like this?
This engine has only had a few NA dyno pulls.

Lynn McHackey probably supplied Used Bearings he had lying around.

Lynn McCarty and BES, What a Disgrace, this engine build has more issues/problems/mistakes than I have ever seen.

The word "Thief" comes to mind when you think you are working with Reputable People/Companies and this is the End Result. Not only was Ed's Money Stolen, think of all the time lost, stress involved and now try to Salvage and rebuild this Brand New Engine.
GREAT JOB LYNN!!!!!

Glad there are other RAV Heads coming out by a Different Supplier.

[73 TRANSAM]

What brand is the crankshaft? It seems like nobody check the clearance or maybe the bearing crush is minimal and the elongated cut in the saddle were leaking out in the side. But either way it seems like you are rebuilding your brand new proffesionally built engine. Like I said you are a better person than most of us. Goodluck at least you caught all these issues before making some power on this engine.

[RAIV-Z]

Originally Posted by 73 TRANSAM

What brand is the crankshaft? It seems like nobody check the clearance or maybe the bearing crush is minimal and the elongated cut in the saddle were leaking out in the side. But either way it seems like you are rebuilding your brand new proffesionally built engine. Like I said you are a better person than most of us. Goodluck at least you caught all these issues before making some power on this engine.

The crankshaft is a Crower Billet.

[gene simmons]

Originally Posted by 67'7F6'Bird

Lynn McHackey probably supplied Used Bearings he had lying around.

Lynn McCarty and BES, What a Disgrace, this engine build has more issues/problems/mistakes than I have ever seen.

The word "Thief" comes to mind when you think you are working with Reputable People/Companies and this is the End Result. Not only was Ed's Money Stolen, think of all the time lost, stress involved and now try to Salvage and rebuild this Brand New Engine.
GREAT JOB LYNN!!!!!

Glad there are other RAV Heads coming out by a Different Supplier.

x2
It gets more painful with every new photo that is posted.
Ed,i think you have the right people on it now. What happened to the rest of your signature?


Thanks for posting Marty,its good to have your input.