| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
07-20-2013, 05:16 PM
|
||||
|
||||
Short Set Screws epoxied into the hole to where they just seal should still give you more than enough thread engagement for any accesory drive component, (especially if you are fixing only one hole) and you can still run a normal fastener (slightly shortened) with no water leaks from then on. As Mike says, more common that you would think, More of a normal checkout process on the heads.
Tom Vaught
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
