| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
|
#1
07-23-2013, 02:31 PM
|
||||
|
||||
Windshield Urethane works great for this! I used it on my '64 where the factory sealant had loosened. You only need a small hole in the applicator tip.
Simply push the hood sheet metal up away from the bracing, squirt a small amount of urethane into the opening, repeat for each "donut" that's loose. I've not had any of these come loose after doing this two years ago. Some said this was going to pull dimples into the sheet metal due to the strength of the urethane, but I see no way this could happen.
__________________
BONESTOCK GOATS '64 GTO Tripower Hardtop (Wife's Car) '64 GTO Tripower Post Coupe (My Car) '99 Bonneville SE Sedan |
|
#2
07-24-2013, 10:48 PM
|
||||
|
||||
|
Quote:
__________________
________________________________________ 65 GTO owner since 84 original ca car 
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
