12-31-2013, 09:50 PM

Half-Inch Stud Half-Inch Stud is offline

Ultimate Warrior

Join Date: Jul 2000

Location: BlueBell, PA or AL U.S.A.

Posts: 18,892

R&D parts
Engineering Prototypes
LRIP
Production

and to cloud my point: Special production runs (usually low rate)

My opinion: any supplier limited to pre-production versus ...Production Suppliers

Figure the SD-455 to be a Production engine. Making the SD part suppliers Production Suppliers.

Reply With Quote

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 07:01 PM.

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

Menu

About Us