[Bentwheelbob]

Originally Posted by njsteve

The car is a 12B car built during the second week of December but delivered in January, so the belts are the originals. If I remember correctly, those black plastic covers are just snapped over the chrome bracket with four little "fingers", so you can gently pry the edge with a plastic pry tool.

That grommet is a common piece used in several locations around the front end of the car, and during the entire span of the second generation era.

My bad on the production date. I got lazy and instead of looking at the trim tag, just looked at the GM Canada document which was right in front of me and lists 1/11/1972 as the production date. Is it unusual that there would be almost a month between production and delivery? There is another thread on here regarding the method of should belt retention and when the change in methodology occurred. December had been referenced as the date of change.

On the grommet, it is good to know they were widely used. Maybe that will increase the likelihood of someone knowing where one can be obtained.

Originally Posted by transam1972

BOB..it looks as though you are missing a rear coot hook..I have 2 new ones I can send you if you like they are close, even though they advertise as an exact reproduction they are not..however they are GM S.R.that I got quite awhile ago..just let me know.if you could do me a huge favor the next time you take some engine pics (I like the way yours are gigantic!)..could you take a shot of your harness route by the front of your drivers side valve cover.(I added a 1976 wire shield and would like to see how an original was done)...

Glenn, I would be happy to send you some pictures. PM me your email address. I'm not an expert, but I don't believe the 1972 455HO used a wire shield mounted to the front head bolt stud. There are several threads and posts around here regarding the proper routing and the various clips needed. You're right on the coat hooks - both are missing.

[njsteve]

BTW, from the photo, the grommet looks fine, just dirty. Those grommets are supposed to have the slit in them from the factory.

I remembered another thing about the black cover - I think it is hinged at the rear with one half of the flange under the metal bracket and the other half that snaps onto the metal as a decorative cover. So be careful not to rip the hinge. Is your garage heated? You could also use a heat gun to warm up the plastic before you pry. That way it won't crack.

[transam1972]

here are some pics of my grommet and coat hook..as you can see mine also has a slit so that may be the way its made..this is an original coat hook..AMES lists 2 different ones for 67 to 72..page 65FA808 look to be the right ones..I ordered FA807 for whatever reason and must have sent them back..sorry

[Gator67]

Here's how mine are set up…I guess I could insert the belt on the outside in the plastic clip

[Judge273]

Thanks!