[RamAir]

Glen, I'm interested in the spark plug wire guides/holders. Do you know if they're available?

[transam1972]

YES...page 185 of AMES #FN417R for $10...for 4...P.Y. may sell them as well as INLINE TUBE...my N.O.S. looms came with them....they are for the unitized distributor and points wires...any problems and I have an extra set, I could give you

[transam1972]

I AM MISSING THIS CLIP????...ANYONE...

[transam1972]

I DID A REVISED ENGINE HARNESS ROUTE...THIS LOOKS MORE CORRECT..AND I AM KEEPING THE 1976 POSITIVE BATTERY SHIELD..APPEARS THIS DESIGN STARTED IN 1973

[transam1972]

I have been looking at my 72 assembly manual,,,I do not think the last post with pics is correct,,,one more try,,,the harness should turn right down the front of the valve cover on an 80 amp set up...opinions?

[Bentwheelbob]

Glenn,

On the Black Car the harness turns down and runs down the face of the block on the passenger side of the alternator/power steering bracket. You can see this in Figure 12-55 of the service manual or the pictures below.

[transam1972]

thanks for posting the photos Bob!!!

[SD73]

Originally Posted by Bentwheelbob

Glenn,

On the Black Car the harness turns down and runs down the face of the block on the passenger side of the alternator/power steering bracket. You can see this in Figure 12-55 of the service manual or the pictures below.

Hello Bob, I'm checking out your throttle cable bracket and it jarred a new quandary in my noggin. Do you know if that's an original part to your car? I'm not sure, but I thought the ones with two holes on the side were for hipo motors and the 3 holed ones were for those that got the turbo 350 trans. Any clarification you or anybody else has would be terrific!