| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
03-10-2014, 07:29 AM
|
||||
|
||||
I can't seem to find the bolt measurement photo so I will take it again and post it.
|
|
#2
03-10-2014, 04:57 PM
|
|||
|
|||
|
REAR ALTERNATOR BRACKET MOUNTING
thanks to P.Y. MEMBER OL PINION HEAD I have a rear alternator bracket and spacer, the spacer is the same ones used on the power steering pump (available in repo kit for $39,not good MOTORCITY MUSCLE CARS)..I installed the clip where I believe it should go..however that causes the connector to be to short to plug in..I can easily lengthen the connector an inch or mount the clip differently for greater length..plus I am still hunting down hardware..it seems wherever a regular washer goes, I got a lock washer instead..I have measured every bolt and it matches the assembly so far..as for lock washers its probably whoever assembled it..as all parts are similar in the general vicinity..I know, complete madness..
|
|
#3
03-10-2014, 05:05 PM
|
|||
|
|||
|
REAR ALT. BRACKET MOUNTING
|
|
#4
03-10-2014, 07:25 PM
|
|||
|
|||
|
REAR BACKET INSTALLED
rear alternator bracket is installed as is connector...a bit tight, more than I like but would have to compare to original...going by the 72 assembly manual best I can
|
|
#5
03-10-2014, 10:57 PM
|
|||
|
|||
|
SOME REPLACEMENT HARDWARE & N.O.S.CHROME TRIM
|
|
#6
03-13-2014, 01:20 AM
|
||||
|
||||
|
72 TA
Has anyone seen one of these decals with year printed on it.. Funny, it says 72 Trans Am, when the 70 & 71 is same.
|
|
#7
03-13-2014, 03:19 AM
|
||||
|
||||
|
Quote:
__________________
" Long may we DRIVE !" |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
