 |
|
| Pontiac - Boost Turbo, supercharged, Nitrous, EFI & other Power Adders discussed here. |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-14-2014, 01:32 AM
|
||||
|
||||
Hey Bruce. Didn't think of my Sawz-all but it is an alternative. I have some cut off Stainless 4 inch pipe yet I can test it on. It's out there for all to see so I want a nice clean straight cut. My new (old used) band saw and new blades do not want to cut the stainless. However, it does seem to be running to fast for this cut. Maybe try slowing down the saw speed and see if that helps. It seemed as thought it was tying to melt the stainless instead of getting a bite and cutting. My old horizontal saw was slower and it seemed I could cut anything on it, as long as I could fit it in the limited opening.
Mark
__________________
My Gasser '63 Catalina build. Oh sorry, it's a Street freak. Either way it's a fun build. |
|
#2
03-14-2014, 10:52 AM
|
||||
|
||||
|
Looking "prudy" Mark..
 Not being a turbo guy....are mufflers required for street driving.....or does turbos quiet it down..?
__________________
 ECM member. 2008 Outlaw Pontiac Drag Series Champion MANDRA Do it now fool! Life is short. 69 Grand Prix/3163lbs / IAII 535 w/ Tiger heads by Gaydosh....9.35@ 144 so far.. through mufflers. 1.26 60'. Going back to track with pump gas engine.... My 60 Ventura retired to street/strip duty.. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
