[Pepi]

Originally Posted by Old Goat 67

Pepi,
Drawing is weird there. There are two rectangular connector blocks up there on top left.
One has only 4 wires, other one has 7???
Tan lead only goes through one? Could that mean that it represents the ribbon cable itself with connectors on either end?

The one with four would be near the tail panel for the light wiring?

Charles

Link posted again for clarity.

Yes, I think you are right. When I look at that connector, (when I printed it out, it cut off half way through the top bulb) right above it shows the door switch. Obviously that wouldn't be back by the rear connector . So your though of it representing the ribbon cable would be something I would put money on.

Adam, I forgot you were getting 2.8V at that one point and still couldn't get gauge to read correctly. Turning the connector around on the gauge is a good idea.