| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
12-12-2014, 04:25 PM
|
||||
|
||||
NAPA - BALKAMP
665-1141 They were 8 to a box for around $5.00, For those who need them for the trim piece I am using them for, the threads that protrude through the trunk lip do look slightly long and may need to be cut or ground off, so they don't interfere when closing the trunk lid.
__________________
I don't always cross thread the bolt - but when I do I run that bitch in with an impact until it's tight! |
|
#2
12-14-2014, 08:23 PM
|
|||
|
|||
|
I'm stripping my car down for a frame off and just took the deck lid trim off. It's a February built Fremont car. The measurement from the left edge is 1" to the center of the first hole, 9 5/8" to the second, 17 1/2" to the third and 25 1/32 to the fourth. From the right side the first hole is 1" on center from the edge, the second is 9 11/32 from the edge, the third 17 1/2" and the fourth 26 3/16. All holes were 1/4" on center from the bottom edge of the lid.
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
