[twinturrbo406]

Originally Posted by BADDTA

Isn't this thread about canted valve heads? Fultons and Jacks in particular!

Brian

... i know right ? ... like the ones below ...

[BruceWilkie]

Originally Posted by twinturrbo406

... i know right ? ... like the ones below ...

Your 434" stock block street motor looks close to dyno time. Sweet.

[LiL Jack]

Originally Posted by twinturrbo406

... i know right ? ... like the ones below ...

Do you think it will make more power then BADDTA's sons Jake 428 pump gas motor?

[twinturrbo406]

Originally Posted by LiL Jack

Do you think it will make more power then BADDTA's sons Jake 428 pump gas motor?

... not sure, this is the first one of these that's been built, but we're going to find out ...

... what do you think it will make Jack ? ...

[LiL Jack]

Originally Posted by twinturrbo406

... not sure, this is the first one of these that's been built, but we're going to find out ...

... what do you think it will make Jack ? ...

Chit, I dunno. I'm just a plumber.


With the small inches and low compression around 750?

I honestly think the intake with the long runners and being that big will hurt power.

When I had a pump gas motor in my 65 back in the mid-late 90s I had a torker II with a spacer and it ran low 11s. The Victor came out and it looked so good I had to have one. I put it on and the car slowed down a tenth!

[Tom McQueen]

For the public school dropouts.
---------------------
Menusha;
Menusha is a slang term that means 'stuff no one cares about because it's so stupid'; 'useless information'.
---------------------
Impossible to read thru all the menusha in this thread. Like so many others here.

But after an attempt to do so, the only thing that came to mind was ...'circle jerk'.
The usual suspects doing what they do best.