[i82much]

Originally Posted by poncho-mike

I don't race, but I built several high performance engines for street cars over the years. H-O Specialties used to sell a set of galley plugs, and the one inside the block had a hole drilled into it to lubricate the distributor get.

I never was sure if that was needed or not for a street car. Does anyone still do that?

Yes, this was something I specifically requested my shop to do when building my engine.

[gman005]

The gear had some dyno pulls and about 10 runs on it. I have the oil hole at the gear. It's a 80lb pump from Butler.