[cnc]

Nice numbers Lee...!!!!
The exhaust is it mandrel bent 3 inch tails.....???? And mufflers are they off set /centre outlet mufflers

[Lee]

Originally Posted by cnc

Nice numbers Lee...!!!!
The exhaust is it mandrel bent 3 inch tails.....???? And mufflers are they off set /centre outlet mufflers

Thanks, I'm happy with it at this point! With the compression so low (114cc chambers, .022" avg piston down the hole, beveled edge pistons) I wasn't sure if the motor could break 250 at the wheels.

The tails are mandrel bent. They are Steve Coombes' old tailpipes, from a previous system he had on his car. My exhaust guy had to make a couple of cut/twist/rewelds to get them to fit the way he wanted with my mufflers and nuances to my car.

The mufflers are offset inlet, center outlet. The headers have slip-on collectors, so my exhaust guy installed flanges at the muffler inlet to allow the system to be dropped from there. Flanges were also added to the muffler outlet side to make the tails removable. I may test that later on.