[bad69bird]

Originally Posted by johnta1

Any pics of the BES oiling mod to the block and crank?
How about pics of the crank oil holes on mains and rods?


Is the rear seal area smooth or cross-hatched?


Thanks.

John,

IMO, I don't think that would be fair to BES to put that out there. They are in business to make money. It would be different if he came up with it himself and he wasn't going to market it. Jeffy might and that's his pejorative.

[johnta1]

Jeffy might and that's his pejorative.

I think that should be prerogative?



That's fine on BES thing.
It's probably well known anyway to most builders.
Goes along with Quality machine work

[bad69bird]

Originally Posted by johnta1

I think that should be prerogative?



That's fine on BES thing.
It's probably well known anyway to most builders.
Goes along with Quality machine work

Haha got me on that one! Damn phone! Lol

[Jeff Kinsler]

Originally Posted by bad69bird

John,

IMO, I don't think that would be fair to BES to put that out there. They are in business to make money. It would be different if he came up with it himself and he wasn't going to market it. Jeffy might and that's his pejorative.

Yea I will not post it for the reason above but anyone can send their stuff there to get it machined. I think it actually was talked about on py somewhere and people were saying that's not a good way to do it.

[[email protected]]

Originally Posted by Jeff Kinsler

Yea I will not post it for the reason above but anyone can send their stuff there to get it machined. I think it actually was talked about on py somewhere and people were saying that's not a good way to do it.

I bet I can guess the players in that one Lol

[Aaron Quinton]

I don't think BES owns the approach but I appreciate your candor.

Originally Posted by Jeff Kinsler

Yea I will not post it for the reason above but anyone can send their stuff there to get it machined. I think it actually was talked about on py somewhere and people were saying that's not a good way to do it.