| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
04-29-2019, 02:00 PM
|
|||
|
|||
"This cam produced 387HP and 439 Ft Lbs of Torque when paired with Performer intake manifold # 2156 and Performer RPM cylinder heads # 60599."
Bingo... |
|
#2
04-29-2019, 02:07 PM
|
|||
|
|||
|
Note here it indicates a single-plane intake in the attached dyno chart. ..
https://www.edelbrock.com/performer-...3-v8-2157.html .
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 ) Old information here: http://www.hotrod.com/articles/0712p...tiac-trans-am/ Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine) Best time 5.13 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension https://www.youtube.com/watch?v=qDoJnIP3HgE |
|
#3
04-30-2019, 08:17 AM
|
||||
|
||||
|
Your light on final gear IMHO for a 400, that's likely a big contributor to weak low end performance with larger cam causing heavy load leading to knocking. Realize those are RAIV heads on serious steroids, RAIV used 1.65 rockers and 4.10 (minimum) rear gear. A well selected roller cam setup could really make good use of those heads.
It's all good, time will tell, if it does what you want well, enjoy it.Looks like a nice ride! 
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
