| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
11-16-2019, 01:48 PM
|
|||
|
|||
Don't know why these things like to stick in the down position, but they do.
Could be the extra current required to get the window moving up. IDK A good bumb with the palm of your hand usually gets them moving. Not so hard that you tear up the door panel. But hard enough that you rattle the window motor. Clay |
| The Following User Says Thank You to "QUICK-SILVER" For This Useful Post: | ||
|
#2
11-16-2019, 02:51 PM
|
||||
|
||||
|
Quote:
__________________
 frittering and wasting the hours in an off hand way.... 1969 GTO, 455ci, 230/236 Pontiac Dude's "Butcher Special" Comp hyd roller cam with Crower HIPPO solid roller lifters, Q-jet, Edelbrock P4B-QJ, Doug's headers, ported 6X-8 (97cc) heads, TKO600, 3.73 geared Eaton Tru-Trac 8.5", hydroboost, rear disc brakes......and my greatest mechanical feat....a new heater core. 
|
|
#3
11-16-2019, 05:43 PM
|
|||
|
|||
|
Put a test light in the circuit with your jumper wire. That will tell you if any power is going through the motor/brushes.
If the light don't come on I'd still give the door panel a few good whacks. If it's only one brush that's not making contact, the light may come on dim. And I'd still give it a whack to try and get it to run. Clay |
| The Following User Says Thank You to "QUICK-SILVER" For This Useful Post: | ||
|
#4
11-16-2019, 11:42 PM
|
||||
|
||||
|
Give it the good whack while you are trying to get it to move, not before, but during, like you would an old starter that was about worn out.
"Bill"! |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
