[ponjohn]

Any updates?

[wbnapier]

Originally Posted by ponjohn

Any updates?

I spoke to the machinist on Friday. He had just received a new set of main bearings that he needed to make a couple of tests, specifically a new #5 bearing. He said he'd do those today or tomorrow and let me know.

His goal is to get some specific measurements on the radius fillet, bearing width, bearing chamfer, endplay, interference, etc... before I contact Butler and Scat.

I read through the warranty info on Butler's and Scat's website and don't see any meaningful recourse based on the specifics of their written warranty, assuming I can demonstrate a clear manufacturing error.

Let's say Butler/Scat acknowledge an error, what can I expect?

After this, I'll get a quote, soup-to-nuts, on a long block and evalauate what I can swing.

I will post on this thread as soon as I get an update.

[MarkS57]

Originally Posted by wbnapier

I spoke to the machinist on Friday. He had just received a new set of main bearings that he needed to make a couple of tests, specifically a new #5 bearing..

Hi did he say which mains he ordered? Should be what came with the stroker kit.