[GoatZillaRacing]

Originally Posted by TedRamAirII

IDK. I like the idea of the Dog Bones. If that plate has enough clearance, the lifter can twist slightly, and put side loads on the roller. I don't think they can tolerate much of a side load? That plate would be good, as amore rigid way to hold the dog bones down. But I don't like the idea of the dog bones jumping up and down when the flats of the lifters run into them. Just thinking out loud, why not grind the flats of the lifters longer with a surface grinder? I really like this idea though!

Adjusted properly the lifters have less movement side to side than with any Milkbone! The Arrow Injuneering Roller Lifter Guide Plate System is the only way to go! Step Up To The Plate!

[Scarebird]

Originally Posted by GoatZillaRacing

Adjusted properly the lifters have less movement side to side than with any Milkbone! The Arrow Injuneering Roller Lifter Guide Plate System is the only way to go! Step Up To The Plate!

I have to smile at your marketing.

I was looking at using BBC 502 roller lifters and grabbing them by the side, but your solution has a certain elegance to it. If I decide to swap out the solids I have I will snap up a set of the lifters you have with the proper oil band.

My prior experience with hydraulic rollers was not good, and Lunati's arrogance concerning their crap product was something to behold.