| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
08-03-2021, 05:57 AM
|
|||
|
|||
Thanks Geoff. I’ve realized that the option you mentioned is the only probable way possible. I’ll make it work somehow.
|
|
#2
08-03-2021, 09:27 AM
|
|||
|
|||
|
Did the cut and weld years ago on a chrysler mini van to get rid of computer timing control. Used a 2.3 ford distributor and gm 4 pin module.
I had done modified the carb to fixed jet and air bleed. The ford distributor shaft was long enough that it could be cut off, drilled, modified for the mopar gear. Almost too easy Clay |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
