[gtohurstjudge]

I can see by what you've done on your panel fitting that you a stickler
concerning body gaps. That being the case, you are not going to be the least bit happy about how the Ames repro rear bumper fits to the quarters and the tail lights. You need to source a nice rear original bumper core and have it redone.
by the way, your fit of the front bumper to the front fenders and hood is absolutely amazing.....ten times better than the factory fit.

[wagzilla]

Looking sharp. What are you going to do as far as tail lights?

[gtohurstjudge]

It was a few years ago when I bought the new Ames "Premium bumper" and at
that time they were claiming that the fit was "Excellent".

[roger1]

Originally Posted by gtohurstjudge

It was a few years ago when I bought the new Ames "Premium bumper" and at
that time they were claiming that the fit was "Excellent".

I'm keeping my fingers crossed that they either solved the quality control problems or sourced another vendor since you bought yours. It will be about a month or so before I'm ready to do a trial fit.

I did go out to my steel pile and inspected what I think was the original bumper on my car. It does have a number stamped into it in the license plate recessed area.
However, it does have 3 or 4 bends in it and a couple of dings too. If it is restorable, it would need a chrome shop with the correct form to be able to straighten it against.

[68gtoMN]

Originally Posted by roger1

I'm keeping my fingers crossed that they either solved the quality control problems or sourced another vendor since you bought yours. It will be about a month or so before I'm ready to do a trial fit.

I did go out to my steel pile and inspected what I think was the original bumper on my car. It does have a number stamped into it in the license plate recessed area.
However, it does have 3 or 4 bends in it and a couple of dings too. If it is restorable, it would need a chrome shop with the correct form to be able to straighten it against.

Roger, this is likely the date code stamp in the bumper. Our friend Paul has had many original bumpers rechromed / straightened. If you are not concerned wtih 100% originality (as we understand), then the reproduction bumper might solve your needs.

[wagzilla]

Looking sharp. What are you going to do as far as tail lights? Did you look at Digi-tails