| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
03-09-2023, 04:52 PM
|
||||
|
||||
Well this looks like a final product. The opening is elevate a bit from the OEM position ... but I gotta have some meat to have the loop strong enough.
I think I have it at the right angle. One of those deals where you have to commit and see it works to save an otherwise unusable part. I'll probably end up installing some on my nice spare duct that has no clips at all ... although I no longer need one. The tabs on the far ends of the duct will have to have the corners trimmed off or they will hang off the ends a bit ... although I'm not sure if some corners hanging off the end would matter.
__________________
I'm World's Best Hyperbolist !! Last edited by dataway; 03-09-2023 at 05:08 PM. |
| The Following 3 Users Say Thank You to dataway For This Useful Post: | ||
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
