| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
03-17-2023, 06:56 PM
|
||||
|
||||
Quote:
|
|
#2
05-16-2023, 05:30 PM
|
||||
|
||||
|
Body Mount Question
I would love to replace all the body mounts but am afraid of snapping bolts. Most of them are passable but the worst is in the back. What's the best way to deal with these? Any suggestions?
|
|
#3
09-17-2023, 11:35 PM
|
||||
|
||||
|
Okay guys...Thanks so much. I appreciate your input!
|
|
#4
10-04-2023, 10:04 AM
|
||||
|
||||
|
Whew... Thanks guys for the education on Pontiac rear seals! I looked closer and there does seem to have been a little seepage on back side of the pan... possibly the rear seal. Doesn't look like it was terrible though.
After reading what you guys sent, I'm having second thoughts about messing with the rear seal. The reason I bought this engine is that it ran pretty good (according to previous owner and video he sent) and I didn't want to put a lot of money into a 350. Maybe I will just check out the rod bearings and leave the mains and rear seal alone. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
