[Gach]

I don’t know having good compression in all cylinders at least the amount should have, telling me its sucking oil from some where. Good possibility it’s valve seals. Being its happening in a few cylinders. Or valve guides … I have to be there seeing everything for myself to really diagnose what’s going on.

[Gach]

Originally Posted by Shockwave78

The original o rings were pretty much gone, I replaced them with the stock O rings

Ok, O’rings not a good idea, I would definitely have new teflon valve seals installed. And check valve guides for where. I’m guessing this (could) be the issue

[Gach]

If you can, take those cylinders that were getting oil in them, pope valve springs off and see, if those O’ring seals are still good, or if the moved up the valves.

[Gach]

Originally Posted by Shockwave78

What about the pcv system, it did have oil in the valve and hose

Oh yeah, I’ve seen this happen with a bad PVC system not working

[Gach]

Question did car smoke out of the exhaust that you can tell.

[Shockwave78]

Originally Posted by Gach

Question did car smoke out of the exhaust that you can tell.

Only on cold starts pic is a rod bearing

[Shockwave78]

Originally Posted by Gach

I don’t know having good compression in all cylinders at least the amount should have, telling me its sucking oil from some where. Good possibility it’s valve seals. Being its happening in a few cylinders. Or valve guides … I have to be there seeing everything for myself to really diagnose what’s going on.

What about the pcv system, it did have oil in the valve and hose