| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
11-23-2024, 03:01 PM
|
||||
|
||||
Using the hub to center the rotor is the best way, since in the future you might get rotors with that inner hat diameter different than what these are.
Since you state there's a 0.100" hub diameter difference (3.050 vs 3.150), you could get a pair of stainless spacers made which are 0.050 thick. Make them a slight interference fit on the hub and a slip fit in the rotor. Obviously only as wide as the rotor hat thickness, so that they don't interfere with the wheel hub hole. |
| The Following User Says Thank You to hgerhardt For This Useful Post: | ||
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
