[ponchjoe]

Stan,

Did you use the Ford dog bones and LS lifters? If so. How thin did you have to clearance them?

Originally Posted by Stan65

I am in the process of doing the exact same thing to my Brewster 73 D-port auto.

I am going roller. I did the Eagle/Mahle 4.25 stoke kit. I am staying 100% numbers matching on the outside. That being said I also wanted a stock idle. I works with Lee Atkinson to design a cam.

My heads came in at 111cc’s and the pistons measured a 7cc dish. I went 4.185 bore

I’m at 8.6:1

I attached my cam card.

I had additional criteria to run my lifter dog bone setup to dramatically reduce the roller setup cost.

Stan